Datakom DKG-307 Manuel d'utilisateur Page 22

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 54
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 21
DKG-307 User Manual V-42 (24.05.2013)
- 22 -
The unit provides a special function for the fuel solenoid control of a gas engine.
The fuel solenoid of a gas engine is different from a diesel engine. It should be opened after
the cranking has been started and should be closed between crank cycles. The delay between the
crank start and solenoid opening is adjusted using the Gas Solenoid Delay program parameter.
The gas engine fuel solenoid relay function may be assigned to spare relays using Relay
Definition program parameters. Also relays on an extension module may be assigned to this function.
The load shedding feature consists on the disconnection of the least crucial loads when the
genset power approaches to its limits. These loads will be supplied again when the genset power falls
below the programmed limit. The internal Load Shedding function is always active. Any of the auxiliary
relays may be used as the load shedding output.
The dummy load function consists on the connection of a dummy load if the total genset load
is below a limit and to disconnection of the dummy load when the total power exceeds another limit.
The dummy load function is the inverse of the load shedding function, thus the same output may be
used for both purposes.
The parameters used in Load Shedding feature are in the Electrical Parameters Group:
Load Shedding Low Limit: If the genset active power output goes below this limit, then the Load
Shedding relay will be deactivated.
Load Shedding High Limit: If the genset active power output goes above this limit, then the Load
Shedding relay will be activated.
The unit is able to send SMS messages in fuel theft or fuelling conditions.
These SMS messages are sent without creating visible fault condition.
These features are enabled by setting the program parameter Engine Parameters > Fuel
Consumption / Hour to a value other than 0%.
The Fuel Consumption / Hour parameter should be set to a value clearly greater than the
maximum fuel consumption of the engine.
If the fuel level measured from the sender input is decreased more than this parameter in 1
hour period, then a FUEL THEFT sms message is sent to programmed telephone numbers.
If the fuel level measured from the sender input is increased more than this parameter in 1
hour period, then a FUELLING sms message is sent to programmed telephone numbers.
6.21. Fuel Theft / Fuelling Messages
6.20. Load Shedding / Dummy Load
6.19. Gas Engine Fuel Solenoid Control
Vue de la page 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

Hotpoint WMF 560 P (UK).R Handbücher

Bedienungsanleitungen und Benutzerhandbücher für Waschmaschinen Hotpoint WMF 560 P (UK).R.
Wir stellen 1 PDF-Handbücher Hotpoint WMF 560 P (UK).R zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung






Weitere Produkte und Handbücher für Waschmaschinen Hotpoint

Modelle Dokumententyp
NM11 824 WC A PL Betriebsanweisung   Hotpoint NM11 824 WC A PL Setup and user guide, 4 Seiten
WMF 760 P (UK).R Bedienungsanleitung   Hotpoint WMF 760 P (UK).R Instruction for Use [ru] , 16 Seiten
WMUD 962 G UK Bedienungsanleitung   Hotpoint WMUD 962 P UK Instruction for Use, 16 Seiten
WDL 540 G (UK).C Bedienungsanleitung   Hotpoint WDL 540 G (UK).C Instruction for Use, 16 Seiten
WMUD 942X UK Bedienungsanleitung   Hotpoint WMUD 942X UK Instruction for Use [el] , 16 Seiten
WMD 942K EU Bedienungsanleitung         Hotpoint WMD 942K EU Instruction for Use [it] , 36 Seiten
WMF 740 G (UK) Bedienungsanleitung   Hotpoint WMF 740 G (UK) Instruction for Use, 16 Seiten
WMFG 611P UK Bedienungsanleitung   Hotpoint WMFG 611P UK Instruction for Use [sk] , 16 Seiten
WMYL 6151P UK Bedienungsanleitung   Hotpoint WMYL 6151P UK Instruction for Use [tr] , 16 Seiten
AQ107D 49D IT Bedienungsanleitung    Hotpoint AQ107D 49D IT Instruction for Use, 24 Seiten
RSG 724 J PL Bedienungsanleitung    Hotpoint RSG 724 J PL Instruction for Use, 24 Seiten
WMAQL 721A UK Bedienungsanleitung   Hotpoint WMAQL 721A UK Instruction for Use [nl] , 16 Seiten
HV7L 1451P UK Bedienungsanleitung   Hotpoint HV7L 1451P UK Instruction for Use, 16 Seiten
AWF 592 Bedienungsanleitung   Hotpoint AWF 592 Instruction for Use [es] [it] , 30 Seiten
FMG 843XR EU Bedienungsanleitung    Hotpoint FMG 843XR EU Instruction for Use, 36 Seiten
AQ113DA 697S UK Bedienungsanleitung   Hotpoint AQ113DA 697S UK Instruction for Use, 16 Seiten
FML 703 EU.M Bedienungsanleitung    Hotpoint FML 703 EU.M Instruction for Use, 24 Seiten
FMG 723M EU Bedienungsanleitung     Hotpoint FMG 723M EU Instruction for Use, 36 Seiten
WDAL 9640G UK Bedienungsanleitung   Hotpoint WDAL 9640G UK Instruction for Use [da] , 16 Seiten
AQ114D 69D E UK Bedienungsanleitung   Hotpoint AQ114D 69D E UK Instruction for Use [es] , 16 Seiten